Rep. Thomas Holbrook

Filed: 2/23/2011

 

 


 

 


 
09700HB1089ham001LRB097 06434 HLH 50217 a

1
AMENDMENT TO HOUSE BILL 1089

2    AMENDMENT NO. ______. Amend House Bill 1089 on page 6, line
31, by replacing "Section 221" with "Sections 221 and 222"; and
 
4on page 6, immediately below line 14, by inserting the
5following:
 
6    "(35 ILCS 5/222 new)
7    Sec. 222. Credit for mechanical insulation. For each
8taxable year beginning on or after January 1, 2011, each
9taxpayer is entitled to a credit against the tax imposed by
10subsections (a) and (b) of Section 201 of this Act in an amount
11equal to the applicable percentage of the cost of mechanical
12insulation property placed in service in the State during the
13taxable year.
14    In no event shall a credit under this Section reduce the
15taxpayer's liability to less than zero. If the amount of the
16credit exceeds the tax liability for the year, the excess may

 

 

09700HB1089ham001- 2 -LRB097 06434 HLH 50217 a

1be carried forward and applied to the tax liability of the 5
2taxable years following the excess credit year. The tax credit
3shall be applied to the earliest year for which there is a tax
4liability. If there are credits for more than one year that are
5available to offset a liability, the earlier credit shall be
6applied first.
7    For purposes of this Section:
8        "ASHRAE" means the American Society of Heating,
9    Refrigerating, and Air-Conditioning Engineers.
10        "Mechanical insulation property" includes insulation
11    materials, facings, and accessory products used for
12    thermal requirements for mechanical piping and equipment,
13    hot and cold applications, and heating, venting, and air
14    conditioning applications.
15        "Cost of mechanical insulation property" includes any
16    amount paid or incurred for the installation of mechanical
17    insulation property that exceeds ASHRAE standard
18    90.1-2007.
19        "Applicable percentage" means the lesser of (i) 30% or
20    (ii) the reduction in energy loss (expressed as a
21    percentage) from the installed mechanical insulation
22    property compared with mechanical insulation property that
23    meets the minimum requirements of ASHRAE standard
24    90.1-2007.".